Page 2 of 2

Re: SplashBase LM3S6x setup for beginner

PostPosted: Mon Jan 13, 2014 9:17 pm
by Carl-SolderSplash
BAUD : 115200
Data Bits : 8
Stop Bits : 1
Parity : None
Flow : None or XON/OFF (Should work with both)

Leave the rest as default.

Connect and Hit enter, you should get a menu.

Re: SplashBase LM3S6x setup for beginner

PostPosted: Thu Jan 16, 2014 7:53 am
by naokibizen
Hello SolderSPlash!

The connestion between Mac and SplashBase Board became successful with the second SplashBase board we have received this week in January. Thus we understand what was wrong with the board now.

Thank you for your kind and super quick assistance and we can go forward now !!

Best Regards, We close the thread.

Re: SplashBase LM3S6x setup for beginner

PostPosted: Thu Jan 16, 2014 10:03 am
by Dave
Could I ask what was the problem with the first board.

This could help other users.

Re: SplashBase LM3S6x setup for beginner

PostPosted: Thu Jan 16, 2014 3:23 pm
by Carl-SolderSplash
naokibizen wrote:Hello SolderSPlash!

The connestion between Mac and SplashBase Board became successful with the second SplashBase board we have received this week in January. Thus we understand what was wrong with the board now.

Thank you for your kind and super quick assistance and we can go forward now !!

Best Regards, We close the thread.


Super! I assume the relays work? I shipped them connected this time to avoid confusion.

Then you can look at relay control over the network with the Android app or PC app.

Re: SplashBase LM3S6x setup for beginner

PostPosted: Sat Jan 18, 2014 1:39 pm
by naokibizen
Hello Dave,

Dave wrote:Could I ask what was the problem with the first board.

This could help other users.

The reason was simple... the first board did not work as expected as the second board does in terms of USB connection. The problem may be caused by our previous misunderstanding of AC Adapter or others.... we will not investigate more than that.

Best Regards,

Re: SplashBase LM3S6x setup for beginner

PostPosted: Sat Jan 18, 2014 1:58 pm
by naokibizen
Hello SolderSPlash,

IThe second SplashBase board works as expected. We can switch on and off for 4 relays -- thank you!!
I guess we have done what we wanted to do. We close the thread now... m(_ _)m

Best Regards,